Types of Flat Roofing and How It Is Applied

Flat roofs can be found all over the world. Every region has its own preference or tradition for roofing designs and installation. The flat roofing is installed almost level in contrast to most sloped roof types. The slope is properly known as the pitch and approximately measured up to 10 degrees. It is mostly used in regions with dry climates and the roof space is commonly used as living space or also called as the living roof. Low sloped roofs are usually found in commercial buildings. In the United States of America, expert roofing idea Noblesville contractors install the flat roof with a 3-in-12 slope or less.

In hot places, where there is not much rain and icy weather is not likely to occur, most flat roofs are plainly made of concrete. It is to drive away the heat of the sun. Flat roofs can be installed easily and have a reasonable cost. Its designs are inspired from Persian, Arabian and Egyptian styles of architecture.

Flat roofing has a covering called membrane. The purpose of these membranes is to make the roof watertight or water resistant. The flat roofer or selected EPDM roofing Noblesville install flat roofs which include membranes that runoff rain from a minimal inclination into a gutter system.

In some occasions, flat roofs are specialized to get water in a pool. It is common for aesthetic ideas or for rain protection.

Common Flat Roofing installed by roofing service company Noblesville in Indiana:

BUR (Built-Up Roof)

The old-fashioned hot tar and gravel roof is made of three plies of waterproofing material or more. The plies are alternated with hot tar and provide stability by a sheet of smooth river stone. This type of flat roofing gradually uses advanced materials like fiberglass membranes.

Rubber Membrane

Ethylene Propylene Diene Monomer or EPDM roof material is a true rubber. It is intended to resist damage from the light of the sun. EPDM roofing can be mechanically installed with fasteners, glued, or ballasted with stone.

Modified Bitumen

Another type of a flat roofing is the single-ply rolled roof akin to ice and water shield, but with a mineral-based wear surface. Some systems include heating the bonding agent as the material is unrolled. Latest systems like peel-and-stick are easier and safer.